SET TITAN V2 COMPLETE MOSFET FOR GEARBOX REAR CABLE GATE (G-TTN-CRR)

TRIGGER SENSITIVITY ADJUSTMENT:
Five trigger sensors allow you to control activation sensitivity.
There is no need to disassemble the AEG. Just use the tactical programming card
or the GATE ™ App control station to adjust the trigger to your preferences
and skill level.

SELECTION OF THE FOCUS configurable (GEN.2):
Two selection sensors allow you to use up to six selection modes
of fire, including the innovative SEMI-BURST-AUTO mode:
-SAFE-SEMI-AUTO.
-SAFE-SEEDS-SEEDS.
-SAFE-SEMI-BURST.
-SAFE-BURST-AUTO.
-SAFE-SEMI-BURST / AUTO (short press - burst, long press - AUTO).
-SEMI-burst-AUTO (SAFE mode via the SAFE-SEMI-SAFE fast switch).

DETECTION CYCLE:
Thanks to the gear sensor, TITAN precisely detects in which position the cycle
it should end. Therefore, even the shortest action limit produces at least
a complete cycle.
Thanks to the cycle detection function you get:
- Automatic BURST - there is no need to set the burst time.
You can set the shutter speed between two and 10 shots;
- Automatic PRE-ARM - Pre-cocking is fully operational, of the
burst and semi auto modes and there is no need to manually set the
pre-cocking thrust. You can simply set the pre-cocking as high,
medium or low;
- FULL CYCLE - when the pre-cocking is off, TITAN guarantees that the reducer
completes a full cycle. You gain greater reliability.

PRE-ARMAMENT (JAN. 2 *):
Winning the game is often a matter of fractions of a second. Thanks to
PRE-ARMAMENT, you gain a trigger reaction similar to a real gun.
It allows for initial spring compression, which accelerates the response of the
trigger significantly.
There are two PRE-cocking modes:
-AUTO MODE - the spring is automatically compressed after each shot,
-SMART MODE - slow action limit compresses the spring, and trigger action
fast fires the shot.
And three BOOST PRE-cocking options: HIGH / MID / LOW
* Pre-arming is now fully operational, in burst and semi auto modes
and there is no need to manually set the pre-cocking thrust.
Please note: in PRE-cocking increments wear on the gearbox.

BURST (JAN. 2 *):
The burst allows you to fire a predetermined number of BBs, which is very useful
in MILSLIM and when using low-ammunition.
* There is no need to set the time to shoot.
You can easily set up burst between two and 10 shots.

ROF CONTROL:
This allows for a reduction in the rate of a gun fire. You use batteries
Stronger LiPos, and still have a ROF, just like in a real gun.

ROF STAB:
It allows you to change the way the ROF control works:
-ON - ROF Control uses PWM to decrease ROF. Thanks to this change
works smoothly what reduces wear on AEG internal parts.
-OFF - ROF control adds pauses between takes to decrease ROF.
It gives you the most realistic experience.

SNIPER DELAY:
It allows you to set the delay between each SEMI shots to simulate the
reload or recoil delay. You can set 0.5s, 1s, 2s or 3s delays.

SMART TRIGGER:
We know how vital the fast trigger response is during combat.
This is why we have developed the Smart trigger function. It allows you to
get faster activation response. Works with the ROF control system.
During the first shot, the microprocessor sets the ROF control to 100%. After
first shot, you pass to a previously programmed value (for example the
50%). Consequently, the first shot is fired to a full ROF, and subsequent shots
to the reduced ROF. The best results are obtained using a battery with a voltage
higher than the standard one. For example, if you are using a 7.4V battery, it is possible
replace it with 11.1V. This way, you'll get a faster trigger response with it
same rate of fire as with a standard battery.
* Only works when ROF STAB is ON.

AUG MODE:
Enjoy two phase triggers. Activate AUG mode and set two different ones
trigger sensitivity. Pulling the trigger lightly produces SEEDS or BURST
and pulling the trigger further produces BURST or AUTO (depending on the mode of the
fire selector).

BATTERY PROTECTION (gen.2 *):
Battery over-discharge protection. Modern LiPo batteries and life are
very sensitive to excess discharge. If you do not want to damage the battery and there
concerned about his service life, this protection is indispensable. The
microprocessor monitors the battery voltage constantly. When the tension
drops to a critical level, will not allow cooking.
* TITAN detects the number of cells automatically. There is no need to
reprogram TITAN every time the battery is replaced.

BATTERY SIGNAL:
When the battery voltage drops to a predefined level,
the motor will vibrate at regular intervals.

SMART FUSE:
We have developed an electronic fuse with accurate current sensor.
A combination of current, voltage and temperature measurements makes the installation
Highly reliable AEG. Protects the MOSFET against overheating, the
overload and short circuit. If the airsoft gun gets jammed, the function protects
the motor and battery from damage.

ADAPTIVE ACTIVE BRAKE:
It automatically adjusts the braking power of the engine according to your own
needs. This prolongs the life of the engine.

MOSFET:
Want to get a higher ROF and a faster trigger response? You have plans
a power upgrade of your gun? In that case, a MOSFET is required.
It directs the energy from the battery directly to the motor, bypassing the trigger
mechanical. As a result, you earn a higher ROF of the gun and a
faster trigger response.

BUILT-IN SELF-TEST:
This allows you to quickly check if the drop-in module is working properly.
Helps pinpoint where the problem is when something goes wrong.

COATING:
Thanks to its special conformal coating, the product is resistant to
atmospheric conditions (Military Specification MIL-V-173C).

DEANS-T READY:
The product has low resistance factory fitted Deans-t connectors.

MINI-TAMIYA ADAPTER:
Thanks to the Tamiya Mini adapters included in the kit, it can be easily connected
the drop-in module to your original (default) installation.

14.8V LI-PO READY:
The drop-in module can be used with batteries up to and including 14.8V Li-Po.
The minimum operating voltage is 3V and the maximum is 17V.

PRINTED QUICKSTART:
Make your adventure start easier with a new product. The Quickstart
contains background information and tips.

INCLUDED IN THE KIT:
TITAN Drop-in module (rear wiring).
TITAN Tactical Programming Card.
USB-Link for the GATE Control Station App.
Assembly kit.
Portable operating instructions.

INCLUDED IN THE KIT:
TITAN Drop-in module (rear wiring).
TITAN Tactical Programming Card.
USB-Link for the GATE Control Station App.
Assembly kit.
Portable operating instructions.