MOSFET FOR P90 TOKYO MARUI STD PERUN (P9-XX-XX)

Perun for P90 replaces the trigger bar and mechanical contacts in your P90 replica and offers many useful functions. Magnetic sensors coupled to a magnet installed directly on the trigger, allow you to remove the bar connecting the trigger to the gearbox, making the trigger pull much smoother. The proprietary interrupt lever (supplied with the mosfet) works with an optical sensor to eliminate all problems with the single fire function.
Replicas compatible with this mosfet are models made by: Tokyo Marui, ACM, Asia Tactical, Classic Army, Cybergun, CYMA, Double Bell, J Tactical, JG. King Arms' P90 and Novritsch's SSR90 are mostly compatible, but require some modifications. Perun for P90 is not compatible with G&G and Krytac P90.

Adjustable Trigger Sensitivity – The trigger can be set to 5 sensitivity levels for both the first and second stages of the trigger, ranging from the short pull needed to fire a shot, to a long pull. No modification to the trigger or gearbox is required, and changing the trigger feel is also possible in the field.
Selectable Shooting Modes: The user can choose the shooting modes available after a short or long trigger pull: SEMI SOLO, BINARY, SEMI-AUTO, SEMI-BURST, BURST-AUTO.
Active brake - the active brake stops the motor after each shot avoiding spring compression or in case of high rate of fire, overspin (double shot problem) reruns.
Preload- Quick trigger response can be a matter of win or loss, especially in CQB situations. With precocking enabled, the piston will remain in the rearward position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after pulling the trigger. To release the mainspring after using the pre-cock, pull the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without pre-cock and fully braked.
Binary Trigger - Allows for easy double shots in semi-auto mode. After enabling this mode, if semi-automatic fire is set, shots will be fired not only when the trigger is pressed, but also when it is released.
Rate of fire reduction - Reduce the rate of fire in automatic or burst mode to save ammo or make the replica more realistic.
Low Battery Voltage Alarm - Dedicated to Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be warned by short beeps that repeat every minute. This can also be turned on and off freely.
DSG - A sector gear sensing mode specially crafted to work with dual sector gears.
Diagnostic system - constantly monitors the replica and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting much easier.
Electronic Fuse- It will save your replica and battery in case of a serious malfunction. It will automatically disconnect the battery when a short circuit or motor stall is detected.

Programming of all settings is carried out exclusively using a button and a multi-colored LED diode mounted in the battery compartment and the trigger. This allows settings to be changed at any time, in seconds, even under enemy fire. All settings are set independently for each switch position, so you can program the mosfet exactly the way you want it, i.e. semi to semi and binary trigger to auto.
Perun for P90 works without problems with any battery from 7V to 17V. It can be used even with the most extreme configurations.

MANUAL