MICRO ACTIVE BRAKE II MOSFET WITH JEFFTRON CABLES (JT-BRK-W1)

Professionally made mosfet with active motor brake designed for airsoft electric guns (AEG).
In semi-fire mode the piston is not partially stretched, the spring is fully released, the parts in the mechabox are not under strain and the nozzle blocks the lift chamber for the most part (depends on the ROF).
Active break resolves multiple shots in semi mode with very high rate of fire (ROF) weapons.
The device increases the gun's rate of fire and the battery lasts longer than the basic harness.

SPECIFICATIONS:
Very small device, it fits almost anywhere
Wireless devices, max. Power cables 1,5qmm (AWG16) and 0,
Signal cables 5qmm (AWG20)
Suitable for the service center, if you are not familiar with soldering to the printed circuit board, please choose the device with wiring and accessories
Designed for springs up to M160 (equivalent for 75A single shot current or 25A burst fire for max. 30 seconds)
Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
Active braking uses excess energy from the motor to stop it. The braking effect is the most powerful with a high-rotation motor
6-wire connection
Device dimensions 27x10x7mm
No power consumption in idle mode
No spark on the switch contacts
In automatic fire mode, the piston stops in a random position thanks to the mechabox design
For proper operation you must have a functional shift override lever, selector plate, reverse stop, trigger and trigger lock, as it has standard shifting

INSTRUCTIONS FOR THE DEVICE: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 596.09 KB]

PACKAGING: device, heat shrink tubing and installation manual in English

ATTENTION: The installation of this device is entrusted to an expert, who could weld and disassemble the airsoft gun. Never use the welding gun!