ACTIVE BRAKE II MOSFET WITH JEFFTRON CABLES (JT-BRK-W2)

Professionally made mosfet with active motor brake designed for airsoft electric guns (AEG).
In semi-fire mode the piston is not partially stretched, the spring is fully released, the parts in the mechabox are not under strain and the nozzle largely blocks the lift chamber (depends on the ROF).
Active break resolves multiple shots in semi mode with very high rate of fire (ROF) weapons.
The device increases the gun's rate of fire and the battery lasts longer than the basic harness.

SPECIFICATIONS:
Wireless devices, max. 1.5qmm (AWG16) power cables and 0.5qmm (AWG20) signal cables
Suitable for service center, v If you are not familiar with PCB soldering, choose a device with wiring and accessories
Designed for springs up to M210 (equivalent for 150A single shot current or 50A burst fire for up to 30 seconds)
Specified for common batteries up to 17V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
Active braking uses excess energy from the motor to stop it. The braking effect is the most powerful with a high-rotation motor
6-wire connection
Device dimensions 35x13x7mm
No power consumption in idle mode
No spark on the switch contacts
In automatic fire mode, the piston stops in a random position thanks to the mechabox design
For proper operation you must have a functional shift override lever, selector plate, reverse stop, trigger and trigger lock, as it has standard shifting

INSTRUCTIONS FOR THE DEVICE: YOU CAN DOWNLOAD THE INSTALLATION MANUAL IN ENGLISH HERE [PDF, 663.23 KB]

PACKAGING: device, heat shrink tubing and installation manual in English

ATTENTION: The installation of this device is entrusted to an expert, who could weld and disassemble the airsoft gun. Never use the welding gun!